1967 - 1968 Camaro Crankshaft Pulley, Big Block, 3 Groove, 6-3/4" O.D.

Home > Engine Components > Engine Pulleys >

1967 - 1968 Camaro Crankshaft Pulley, Big Block, 3 Groove, 6-3/4" O.D.

Our Price: $284.95

PART NUMBER: ENC-130

Qty:

Description

1967 - 1968 Camaro Crankshaft Pulley, Big Block, 3 Groove, 6-3/4" O.D.

67 - 68 Camaro Big Block 396 / 375hp three groove, with P/S, cast iron crank shaft pulley is now available! This 3 groove BB, cast iron crankshaft pulley is for 1967 - 1968 models with 396 / 427 High Performance engines and power steering. Reproduced exactly as the original including the factory 3869978 GM part number cast in the front.

NOTE ~ This CRANK pulley is for 1967 - 1968 engines with a SHORT LENGTH water pump. Over the years many cars have had an engine swap. Please double check your particular engine and make sure this will work for you.

Made in the U.S.A.

*Important Warning Concerning Crankshaft Pulleys. Stock replacement, aftermarket stamped steel or cast iron pulleys are not designed to exceed 400 horsepower or 6000 RPM. Using reproduction pulleys on engines in excess of these limits may result in catastrophic disintegration of the pulley causing severe damage to the engine, cooling system and body parts. Camaro Central assumes no liability for damages caused by improper usage of pulleys. Please be sure to install the pulley properly to avoid damages that could occur from improper installation or exceeding the recommended RPM limitations.

PART NUMBER: ENC-130