| |
 |
 |
 |
|
Floor pan fit |
July 22, 2012 |
| Reviewer:
Randall Minter from Hopewell, VA United States
|
|
Overall fit was very good and tight. Seams down the sides and front and back were excellent! Two things wrong though the rear seat belt holes were not even close i had to weld them up and trail fit and then re-hole saw out. The other is the angle brakets in the back that the side panels screw into they were welded on backwards creating to much space and not allowing side panels to be mounted. I had to remove them and thank goodness i had saved originals that only had one spot weld in the center that i had drilled out previously upon removal of old floor pan. Also on originals there is an x molded into front of floor pans on each side were as these dnt have so a little difference in appearence. But overall very good tight fit you cant even tell it was put in. These are a few things maybe you want to pass on to the vender of this product cause it is a hassel pulling it in and out of car to fix these differences after youve already measured and trimed. Thanks again
Was this review helpful to you? 
|
|
 |
|
 |
|