Exterior Door Mirror Replacement Glass Silicone Adhesive, 1/2 oz Tube

This Silicone Adhesive is perfect to mount your new replacement mirror glass! Creates a permanent, bonded seal that maintains a strong hold against harsh weather conditions, chemicals, and moisture. This adhesive will mount directly to your mounting plate and the replacement glass can simply be pushed into place. Some models might also require the use of a Adhesive Patches/Pads for installation, see part number EXM-70.

DRIES IN 10 MINUTES, FULLY CURES IN 24 HOURS!

Resistant to weathering including ozone, UV radiation, freeze-thaw conditions, and airborne chemicals.

PART NUMBER: EXM-73

• Vertical Measurement

  Measure your mirror glass. Measure vertically from top mirror edge to bottom mirror edge.

  

  Horizontal Measurement

  Measure your mirror glass. Measure horizontally from left mirror edge to right mirror edge.
  

  Diagonal Measurement

  Measure your mirror's longest diagonal measurement. This mirror's longest measurement happens to be from the inside upper to outside lower.

  

STEP 1: REMOVE ALL BROKEN GLASS: Remove all existing broken glass and adhesive from the mirror's plastic frame and backing plate with a putty knife.
STEP 2: CLEAN & TEST FIT: Thoroughly clean backing plate with rubbing alcohol. Clean mirror with glass cleaner. Test fit your Replacement Mirror Glass before proceeding to the next step.
STEP 3: APPLY ADHESIVE: Apply Silicone Adhesive or Redi Stick™ adhesive patches to the backing plate or mirror replacement, if applicable. TIP: Install in a warm/dry environment. TIP: In addition to adhesive patches, you may supplement silicone or urethane.
STEP 4: INSTALL Replacement Mirror Glass: Align and press mirror replacement to the backing plate with firm yet gentle pressure.
STEP 5: CLEAN UP: Clean your installed Redi Cuts® mirror replacement with glass cleaner